Eldersburg, MD

I was called to a home to fix a leak coming from the tub. Upon inspection, I discovered that the tub and shower valve was faulty. I replaced it with a new Moen Positemp valve and replaced all the chrome trim.

I was called to a residence to repair a leaky faucet. Upon arrival, I discovered that the issue was caused by a buildup of mineral deposits in the aerator screen. I removed the screen and cleaned it thoroughly with a small brush. Afterward, I reassembled the faucet and tested it to ensure it was functioning prope

Adjusted temperature on a moen positron valve.

I repaired a leaking toilet in Eldersburg, MD by replacing the faulty fill valve and flapper in the tank. After adjusting the water level for proper flushing, I tested the toilet to ensure no further leaks. The system is now working as it should.

I was called to repair a section of Wardflex CSST tubing that had been damaged by a contractor. After inspecting the damaged section, I removed it and installed a new section. Once completed, I tested the gas lines to ensure no leaks and proper gas flow. The repair was successful, and the homeowner was pleased with the quick and efficient service. The work area was cleaned up, leaving the home in good order.

I resolved a low water pressure issue in the kitchen. The problem was caused by a clogged aerator and buildup in the supply lines. I cleaned the aerator and flushed the supply lines to clear the debris. After making minor adjustments to the pressure reducing valve (PRV), the water pressure was restored to normal levels, and the faucet is now functioning properly.

I was called to replace a 50-gallon electric water heater in a residential home. When I arrived, I found that the old water heater was leaking from the bottom. I removed the old water heater and installed a new one, ensuring that it was properly secured and connected to the plumbing system. I also tested the water heater to ensure that it was working correctly.

I was called to a home to repair a leaky faucet. Upon arrival, I discovered that the faucet was not the issue. The problem was a broken pressure relief valve. I replaced the valve and capped off the line to prevent any further leaks. The homeowner was grateful for my quick and efficient service.

I repaired a Rheem 50-gallon gas water heater that was not heating water properly. After diagnosing the issue, I replaced the faulty thermocouple with a new one and cleaned the burner assembly to ensure efficient operation. I then tested the system for proper ignition and confirmed that the water heater was functioning normally, restoring hot water to the home.

I performed a drain cleaning on a clogged kitchen sink using a Ridgid K-45 drain auger. The clog was caused by a buildup of grease and food particles. After carefully snaking the drain, I removed the blockage and flushed the line with hot water to clear any remaining debris. The sink now drains properly, and there are no further obstructions.

I replaced an old 50-gallon electric water heater with a new one that the homeowner had purchased. I removed the old unit and disposed of it properly. I then installed the new unit and connected the water and gas lines. I tested the unit to ensure it was working properly and made any necessary adjustments. I also cleaned up the work area and removed all debris.

We replaced the 23 year old sump pump and check valve. We also replace a cracked section of discharge piping and secured piping to prevent movement when pump turns on.

I was called to a home to investigate a suspected leak in the bathroom above the kitchen. Upon arrival, I noticed water dripping from the ceiling above the shower. I investigated further and found that the leak was coming from the shower head itself. I removed the shower head and replaced it with a new one, and the leak was fixed.

I received a call from a customer who reported two slow drains in their home. The first drain was in the bathtub, and the second was in the bathroom sink. I arrived at the customer's home and began to investigate the issue. The bathtub drain was slow because there was a lot of hair and soap scum buildup in the pop-up waste. I used a drain machine to clear the stoppage, and the bathtub drain was flowing smoothly again. The bathroom sink drain was slow because there was a lot of hair and grease buildup in the sink's drain. I used a drain machine to clear the stoppage, and the sink dra

Resolved a low water pressure issue by inspecting the home’s plumbing system. Found a partially clogged aerator in the Delta kitchen faucet and sediment buildup in the supply lines. Cleaned the aerator and flushed the supply lines to remove debris. Checked the pressure regulator and adjusted it to the correct setting. Verified improved water pressure throughout the home. Maintaining clean and unobstructed plumbing components is essential for optimal water flow. For professional plumbing services, contact us to ensure your system runs efficiently.

I am a professional plumber and I recently completed a job installing a sump pump with a check valve. The sump pump is designed to remove excess water from a basement or crawl space, preventing flooding and water damage. The check v

I was called to replace an ice maker valve in a refrigerator. I removed the old valve and installed a new one, ensuring a tight seal. I then connected a steel braided line to the new refrigerator.

Addressed severe sediment accumulation in 3-inch PVC drain line. Utilized high-pressure hydro-jetting equipment with rotating nozzle to dislodge compacted debris. Initial pass at 3000 PSI cleared majority of blockage. Secondary pass with descaling attachment removed mineral deposits adhering to pipe walls. Conducted camera inspection post-cleaning, revealing minor pipe degradation at joints. Recommended annual maintenance to prevent future buildup. Installed cleanout access point for easier future servicing. Advised homeowner on using enzyme-based treatments monthly to mitigate organic waste accumulation and maintain optimal flow characteristics.

I replaced a homeowner-supplied garbage disposal with a new unit. I removed the old disposal and installed the new one, ensuring a tight fit and proper connections. I also tested the disposal to ensure it was working properly.

I was hired to replace an outdoor hose bib. The hose bib was located on the side of the house and was leaking. I removed the old hose bib and replaced it with a new one. I also replaced the old water supply lines and checked the pressure of the water lines.

Today, I replaced an elongated toilet with a round front toilet in a jack and Jill bathroom. The elongated toilet was difficult to use for both children, so I decided to replace it with a round front toilet. The new toilet was installed easily and now both children can use it comfortably.

I addressed tree root blockage in main water line today in Sykesville. Utilized a motorized drain snake with a cutting head to clear roots obstructing the pipe. Conducted a camera inspection to assess the extent of the damage and ensure complete removal of roots. Employed a high-pressure hydro-jetting system to thoroughly clean the pipe interior and prevent future root intrusion. Inspected and reinforced damaged sections of the pipe as necessary. Restored water flow and system functionality.

Diagnosed malfunctioning water heater unit this afternoon in Eldersburg. Flushed sediment from tank. Replaced failed thermocouple and pilot assembly components. Adjusted gas valve and pilot light per manufacturer specifications. Inspected anode rod and temperature/pressure relief valve operation. Ensured proper venting. Tested safety controls. Restored hot water supply to optimal performance and safe operating condition.

I recently completed a job installing a 50-gallon electric water heater with an expansion tank for a customer in the city. The customer had recently purchased a new home and wanted to ensure that their water heater was properly installed to meet their needs. To begin the installation, I carefully removed the old water heater from the space and disposed of it properly according to local regulations. Next, I installed a new 50-gallon water heater in its place, making sure to follow all manufacturer instructions for proper installation. To ensure that the water heater was operating safely and efficiently, I also installed an expansi

Responded to a water heater maintenance call. Conducted a thorough maintenance routine which included draining the water heater to remove sediment buildup. Replaced the water-logged expansion tank to maintain proper pressure regulation. Installed a new temperature and pressure (T&P) relief valve to ensure safe operation and prevent potential overheating or pressure issues. Completed all tasks according to industry standards to enhance the longevity and efficiency of the water heater system.